First Order Crossover Calculator

First Order Crossover Calculator

Calculate an ideal first-order low-pass series inductor or high-pass series capacitor for a nominal resistive load.
Selected first-order component (units in choice):
Support this tool
Buy us a coffee
If this First Order Crossover Calculator helped you, you can support the site with a small donation. It keeps the tools on the site free and supports ongoing improvements.
Buy us a coffee
Secure donation via Gumroad

What this calculator measures

Calculate an ideal first-order low-pass series inductor or high-pass series capacitor for a nominal resistive load.

Inputs and units

Keep all entries on the measurement boundary and unit convention stated below. Example values are editable calculation inputs, not specifications for your equipment or a particular production job.

Input Example value or available basis
Ideal First-Order Electrical Corner (Hz) 2500
Nominal Resistive Driver Model (ohms) 8
First-order component Low-pass series inductor (mH); High-pass series capacitor (microfarads)

Calculation method

Calculate an ideal first-order low-pass series inductor or high-pass series capacitor for a nominal resistive load.

Use L=R/(2 pi f), converted from henries to millihenries, or C=1/(2 pi f R), converted from farads to microfarads.

Worked example

At 2500 Hz with an 8-ohm resistive model, the low-pass series inductor is approximately 0.509296 mH and the high-pass series capacitor approximately 7.957747 microfarads.

How to use the result

Select the output quantity you need, enter compatible values, and compare the result with the independently worked example. Where the form offers several output choices, read the units in that choice; different physical quantities must not be combined into one total.

Limits and checks

The ideal electrical section has a 6 dB per octave asymptotic slope. Actual acoustic response, driver impedance and protection require a complete measured design.

An undefined or out-of-domain combination produces a calculation-failure message. Check the positive denominators, stated input ranges, and any required matching basis before changing the calculation inputs.

References and method

Table of contents