Crossover Capacitor Calculator

Crossover Capacitor Calculator

Calculate one ideal first-order passive crossover component for a nominal resistive driver model. Higher-order networks require a defined topology and additional parts.
Ideal first-order capacitor:
Support this tool
Buy us a coffee
If this Crossover Capacitor Calculator helped you, you can support the site with a small donation. It keeps the tools on the site free and supports ongoing improvements.
Buy us a coffee
Secure donation via Gumroad

What this calculator measures

Calculate one ideal first-order passive crossover component for a nominal resistive driver model. Higher-order networks require a defined topology and additional parts.

Inputs and units

Keep all entries on the measurement boundary and unit convention stated below. Example values are editable calculation inputs, not specifications for your equipment or a particular production job.

Input Example value or available basis
Ideal First-Order Electrical Corner (Hz) 2000
Nominal Resistive Driver Model (ohms) 8

Calculation method

Calculate one ideal first-order passive crossover component for a nominal resistive driver model. Higher-order networks require a defined topology and additional parts.

A first-order series high-pass capacitor uses C=1/(2 pi f R), reported in microfarads. A first-order series low-pass inductor uses L=R/(2 pi f), reported in millihenries.

Worked example

At 2000 Hz with an 8-ohm resistive model, the first-order capacitor is approximately 9.94718 microfarads and the inductor is approximately 0.636620 mH.

How to use the result

Select the output quantity you need, enter compatible values, and compare the result with the independently worked example. Where the form offers several output choices, read the units in that choice; different physical quantities must not be combined into one total.

Limits and checks

Nominal impedance is an approximation. Driver response, protection, acoustic slope, winding resistance, tolerance, and the complete crossover need measurement-based verification.

Do not obtain a different filter order by multiplying or dividing this component value by an arbitrary order factor.

An undefined or out-of-domain combination produces a calculation-failure message. Check the positive denominators, stated input ranges, and any required matching basis before changing the calculation inputs.

References and method

Table of contents