Subwoofer Low Pass Calculator

Subwoofer Low Pass Calculator

Calculate a first-order series-inductor low-pass for a resistive subwoofer model, including a stated inductor winding resistance.
Series inductance for the defined first-order low-pass:
Support this tool
Buy us a coffee
If this Subwoofer Low Pass Calculator helped you, you can support the site with a small donation. It keeps the tools on the site free and supports ongoing improvements.
Buy us a coffee
Secure donation via Gumroad

What this calculator measures

Calculate a first-order series-inductor low-pass for a resistive subwoofer model, including a stated inductor winding resistance.

Inputs and units

Keep all entries on the measurement boundary and unit convention stated below. Example values are editable calculation inputs, not specifications for your equipment or a particular production job.

Input Example value or available basis
Individual or Combined Resistive Subwoofer Model (ohms) 4
First-Order Electrical Corner Relative to Reduced Passband (Hz) 80
Series Inductor DCR Included in the Model (ohms) 0.4

Calculation method

Calculate a first-order series-inductor low-pass for a resistive subwoofer model, including a stated inductor winding resistance.

Transfer is Rload/(Rload + rDCR + j omega L). Its corner relative to the reduced low-frequency passband occurs at L = (Rload + rDCR)/(2 pi f). Low-frequency voltage gain is Rload/(Rload + rDCR).

Worked example

For a 4-ohm resistive model, 80 Hz relative-passband corner, and 0.4-ohm inductor DCR, required L is approximately 8.753522 mH. Low-frequency voltage gain is approximately 0.909091.

How to use the result

Select the output quantity you need, enter compatible values, and compare the result with the independently worked example. Where the form offers several output choices, read the units in that choice; different physical quantities must not be combined into one total.

Limits and checks

DCR must describe the selected real coil and may require iteration with inductance, current, heating, and physical size. A lossless 4-ohm, 80 Hz model instead gives approximately 7.957747 mH.

Real subwoofer impedance, enclosure, acoustic response, filtering/protection, amplifier compatibility, and operating limits are not established. A line-level or DSP filter is a different circuit with different component requirements.

An undefined or out-of-domain combination produces a calculation-failure message. Check the positive denominators, stated input ranges, and any required matching basis before changing the calculation inputs.

References and method

Table of contents