4 Way Crossover Calculator

4 Way Crossover Calculator

Estimate individual ideal first-order components at the three handover regions of a four-way nominal resistive-driver model.
Selected individual component (units in choice):
Support this tool
Buy us a coffee
If this 4 Way Crossover Calculator helped you, you can support the site with a small donation. It keeps the tools on the site free and supports ongoing improvements.
Buy us a coffee
Secure donation via Gumroad

What this calculator measures

Estimate individual ideal first-order components at the three handover regions of a four-way nominal resistive-driver model.

Inputs and units

Keep all entries on the measurement boundary and unit convention stated below. Example values are editable calculation inputs, not specifications for your equipment or a particular production job.

Input Example value or available basis
Lowest Section Corner (Hz) 400
Middle Section Corner (Hz) 1500
Highest Section Corner (Hz) 4000
Woofer Resistive Model (ohms) 8
Lower-Midrange Resistive Model (ohms) 8
Upper-Midrange Resistive Model (ohms) 8
Tweeter Resistive Model (ohms) 8
Individual first-order section Woofer series L at f1 (mH); Lower-mid series C at f1 (microfarads); Lower-mid series L at f2 (mH); Upper-mid series C at f2 (microfarads); Upper-mid series L at f3 (mH); Tweeter series C at f3 (microfarads)

Calculation method

Estimate individual ideal first-order components at the three handover regions of a four-way nominal resistive-driver model.

Each series low-pass inductor uses L=R/(2 pi f); each series high-pass capacitor uses C=1/(2 pi f R). Report each component separately in mH or microfarads.

Worked example

With 8-ohm models and corners 400, 1500 and 4000 Hz, the six individual estimates are approximately 3.18310 mH, 49.73592 microfarads, 0.848826 mH, 13.26291 microfarads, 0.318310 mH and 4.973592 microfarads.

How to use the result

Select the output quantity you need, enter compatible values, and compare the result with the independently worked example. Where the form offers several output choices, read the units in that choice; different physical quantities must not be combined into one total.

Limits and checks

The middle-band high-pass and low-pass sections interact. These isolated section estimates are not a complete acoustic bandpass or optimized four-way design.

Use measured impedance and response, the intended topology, phase and driver operating limits before constructing a practical crossover.

An undefined or out-of-domain combination produces a calculation-failure message. Check the positive denominators, stated input ranges, and any required matching basis before changing the calculation inputs.

References and method

Table of contents