Subwoofer Box Volume Calculator

Subwoofer Box Volume Calculator

Calculate net volume of a rectangular uniform-wall enclosure with separate driver, internal port, and bracing/other displacement allowances.
Net air-cavity volume under the stated geometry:
Support this tool
Buy us a coffee
If this Subwoofer Box Volume Calculator helped you, you can support the site with a small donation. It keeps the tools on the site free and supports ongoing improvements.
Buy us a coffee
Secure donation via Gumroad

What this calculator measures

Calculate net volume of a rectangular uniform-wall enclosure with separate driver, internal port, and bracing/other displacement allowances.

Inputs and units

Keep all entries on the measurement boundary and unit convention stated below. Example values are editable calculation inputs, not specifications for your equipment or a particular production job.

Input Example value or available basis
External Length (in) 24
External Width (in) 16
External Height (in) 14
Uniform Wall Thickness (in) 0.75
Installed Physical Driver Displacement (ft3) 0.12
Internal Port Excluded Displacement (ft3) 0.2
Bracing and Other Internal Displacement (ft3) 0.08

Calculation method

Calculate net volume of a rectangular uniform-wall enclosure with separate driver, internal port, and bracing/other displacement allowances.

Subtract twice wall thickness from each external axis, multiply internal dimensions, divide cubic inches by 1728, then subtract each documented displacement once.

Worked example

External 24 by 16 by 14 inches with 0.75-inch walls gives approximately 2.360026 ft3 gross internal volume. Subtracting 0.12 ft3 driver, 0.20 ft3 port, and 0.08 ft3 other displacement leaves approximately 1.960026 ft3 net.

How to use the result

Select the output quantity you need, enter compatible values, and compare the result with the independently worked example. Where the form offers several output choices, read the units in that choice; different physical quantities must not be combined into one total.

Limits and checks

This assumes a simple rectangular cavity with uniform walls. Double baffles, shared slot walls, partitions, recesses, and irregular geometry require the actual section drawing.

Use installed physical displacement, not cone swept volume, and do not repeat allowances already included in a complete plan. This geometry does not establish a suitable driver alignment or port design.

An undefined or out-of-domain combination produces a calculation-failure message. Check the positive denominators, stated input ranges, and any required matching basis before changing the calculation inputs.

References and method

Table of contents